GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 1998 🢒 Tracker - 4WD 🢒 Body and Accessories 🢒 Doors 🢒 Rear Side Door Stationary Window Replacement

Removal Procedure

    Caution: Wear safety glasses in order to avoid eye damage.

  1. Lower the rear side door window down completely.
  2. Remove the rear side door trim panel. Refer to Rear Side Door Trim Panel Replacement .

    3. Object Number: 352204 Size: SH
  3. Remove the screws and the door trim support bracket from the door.
  4. Peel the water deflector (1) from the door.
  5. Use a flat-bladed tool wrapped in tape in order to gently pry the outer sealing strip from the door.

    6. Object Number: 352226 Size: SH
  6. Remove the rear side door window run (2).

    7. Object Number: 352234 Size: SH
  7. Remove the following components from the door:
    8. • 1 screw (1)
    • 2 bolts (3)
    • The center door sash (5)
  8. Slide the rear side door stationary window (2) out of the vehicle.

Installation Procedure

    Object Number: 352234 Size: SH
  1. Install the rear side door stationary window (2) to the door.
  2. Install the center sash (5) to the door. Secure the sash with the following components:
    3. • 1 screw (1)
    • 2 bolts (3)
  3. Install the window run (2) into the door.

    4. Object Number: 352204 Size: SH
  4. Inspect the water deflector (1) for tears and holes.
  5. In order to repair the tears or holes, use waterproof tape on both sides of the water deflector (1), as needed.
  6. Apply adhesive (2) to the back of the water deflector (1).
  7. Install the water deflector (1) to the door.
  8. Install the door trim support bracket to the door Secure the bracket with the screws.
  9. Install the outer sealing strip to the door by pressing into place.
  10. Install the rear side door trim panel. Refer to Rear Side Door Trim Panel Replacement .