Steering Shaft, Lower Bearing, and Jacket - Disassemble - Off Vehicle Olds

Tools Required

J 41352 Pivot Pin Remover

1. Remove the steering column lock cylinder set. Refer to Steering Column Lock Cylinder Set - Disassemble - Off Vehicle .
2. Remove the turn signal and multifunction switch assembly only. Refer to Turn Signal and Multifunction Switch Assembly - Disassemble - Off Vehicle .
3. Remove the pivot and pulse switch assembly only. Refer to Windshield Wiper and Washer Switch Assembly - Disassemble - Off Vehicle .
4. Remove the ignition switch assembly only. Refer to Ignition and Key Alarm Switch Assembly - Disassemble - Off Vehicle .
5. Remove the tilt spring assembly only. Refer to Tilt Spring - Disassemble - Off Vehicle .



6. Remove and dispose of the lower spring retainer (4).
7. Remove the lower bearing spring (3).
8. Remove the lower bearing seat (2).
9. Remove the adapter and bearing assembly (1).



10. Remove 2 pivot pins (1) using J 21854-01 .



11. Remove the steering column tilt head assembly with the steering shaft assembly from the steering column support assembly.



12. Remove the steering shaft assembly (2) from the steering column tilt head assembly (1).




Important: Mark the race and upper shaft assembly and the lower shaft assembly to ensure proper assembly. Failure to assembly properly will cause the steering wheel to be turned 180 degrees.

13. Tilt the race and upper shaft assembly 90 degrees to the lower shaft assembly and disengage.



14. Remove and discard 4 TORX® head screws.
15. Remove the steering column jacket support assembly from the steering column jacket assembly.

Steering Shaft, Lower Bearing, and Jacket - Disassemble - Off Vehicle Buick

Tools Required

J 41352 Pivot Pin Remover

1. Remove the steering column lock cylinder set and the upper tilt head components. Refer to Steering Column Lock Cylinder Set - Disassemble - Off Vehicle .
2. Remove the turn signal and multifunction switch assembly only. Refer to Turn Signal and Multifunction Switch Assembly - Disassemble - Off Vehicle .
3. Remove the ignition switch assembly only. Refer to Ignition and Key Alarm Switch Assembly - Disassemble - Off Vehicle .
4. Remove the tilt spring assembly only. Refer to Tilt Spring - Disassemble - Off Vehicle .



5. Remove and dispose of the lower spring retainer (4).
6. Remove the lower bearing spring (3).
7. Remove the lower bearing seat (2).
8. Remove the adapter and bearing assembly (1).



9. Remove 2 pivot pins (1) using J 21854-01 .



10. Remove the steering column tilt head assembly with the steering shaft assembly from the steering column support assembly.



11. Remove the steering shaft assembly (2) from the steering column tilt head assembly (1).




Important: Mark the race and upper shaft assembly and the lower shaft assembly to ensure proper assembly. Failure to assembly properly will cause the steering wheel to be turned 180 degrees.

12. Tilt the race and upper shaft assembly 90 degrees to the lower shaft assembly and disengage.



13. Remove and discard 4 TORX® head screws.
14. Remove the steering column jacket support assembly from the steering column jacket assembly.