GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

  1. Remove the outside rearview mirror. Refer to Power Mirror Replacement .
  2. Lower the front door window.

  3. Object Number: 164366  Size: SH
  4. Remove front door outer belt sealing strip screw.
  5. Remove the front door outer belt sealing strip from the pinchweld flange, by lifting up the sealing strip.

Installation Procedure


    Object Number: 164366  Size: SH

    Important: Ensure the front door outer belt sealing strip is aligned properly to the front door inner panel for the screw installation.

  1. Install the front door outer belt sealing strip to the pinchweld flange, align the strip with the screw hole.
  2. Press the strip into place until fully seated.

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the front door outer belt sealing strip screw.
  4. Tighten
    Tighten the outer belt sealing strip screw to 1.5 N·m (13 lb in).

  5. Install the outside rearview mirror. Refer to Power Mirror Replacement .
  6. Raise the front door window.