GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Oldsmobile 🢒 1999 🢒 Intrigue 🢒 Body and Accessories 🢒 Doors 🢒 Front Side Door Window Regulator Replacement

Removal Procedure

    Important: The door window regulator motor and door regulator are serviced as a unit.

  1. Remove the door trim panel. Refer to Front Side Door Trim Panel Replacement .
  2. Remove the water deflector. Refer to Front Side Door Water Deflector Replacement .
  3. Raise and tape the window in the full up position.
  4. Disconnect the electrical connector.

    5. Object Number: 164576 Size: SH
  5. Remove the window to regulator bolts Refer to Front Side Door Window Replacement .

    6. Remove the regulator to door mounting bolts (1,2,3,4).

  6. Remove the regulator motor mounting bolts.

    7. Object Number: 164573 Size: SH
  7. Remove the regulator from the door.

Installation Procedure

    Object Number: 164573 Size: SH
  1. Install the regulator to the door.

    2. Object Number: 164576 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the window regulator to door mounting bolts in the following sequence.
    3. 2.1. Lower rear (1)
    2.2. Upper rear (2)
    2.3. Lower front (3)
    2.4. Upper front (4)

    Tighten
    Tighten the window regulator to door bolts to 10 N·m (89 lb in).

  3. Install the three window regulator motor mounting bolts.

    4. Tighten
    Tighten the window regulator motor bolts to 10 N·m (89 lb in).

  4. Connect the electrical connector.
  5. Remove the tape from the front door window and lower the window onto the window regulator carrier plate.
  6. Install the window to regulator bolts. Refer to Front Side Door Window Replacement .
  7. Install the front door water deflector. Refer to Front Side Door Water Deflector Replacement .
  8. Install the front door inner trim panel. Refer to Front Side Door Trim Panel Replacement .