GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

  1. Open the rear compartment.
  2. Use a grease pencil in order to mark the location of the latch to the rear compartment lid for its location at installation.

  3. Object Number: 182247  Size: SH
  4. Remove the release actuator. Refer to Rear Compartment Lid Lock Actuator Replacement .
  5. Remove the nuts from the rear compartment latch studs.

  6. Object Number: 182240  Size: SH
  7. Disconnect the electric connector.
  8. Remove the rear compartment latch from the rear compartment lid.

Installation Procedure


    Object Number: 182240  Size: SH
  1. Position the latch to the alignment marks on the rear compartment lid.
  2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the nuts to the rear compartment studs.
  4. Tighten
    Tighten the rear compartment latch nuts to 10 N·m (88 lb in)

  5. Connect the electric connector to the harness.

  6. Object Number: 182247  Size: SH
  7. Install the release actuator. Refer to Rear Compartment Lid Lock Actuator Replacement .
  8. Close the rear compartment.