Note: Clean the evaporative emission (EVAP) connections and surrounding areas prior to disconnecting the line in order the avoid possible system contamination.

1. Remove the brake master cylinder and reposition. Refer to Master Cylinder Replacement.
2. Disconnect the EVAP (2) line from the purge solenoid. Refer to Plastic Collar Quick Connect Fitting Service.



3. Open the fuel/brake pipe retainers (1).
4. Remove the EVAP line from the fuel/brake pipe retainers (1).
5. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.



6. Remove the fuel/brake line retainer bolt.
7. Remove the EVAP line from the retainer.



8. Remove the fuel/brake line push in retainer from the underbody.
9. Remove the EVAP line from the retainer.



10. Remove the fuel/brake line retainer bolts.
11. Remove the EVAP line from the retainer.



12. Disconnect the EVAP (4) line from the fuel tank EVAP line (1). Refer to Plastic Collar Quick Connect Fitting Service.
13. Remove the EVAP line.

1. Position the EVAP line.
2. Connect the EVAP (4) line to the fuel tank EVAP line (1). Refer to Plastic Collar Quick Connect Fitting Service.



3. Install the EVAP line to the retainer.
4. Close the fuel/brake line retainer (1).



5. Install the EVAP line to the retainer.

Caution: Refer to Fastener Caution in the Preface section.

6. Install the fuel/brake line retainer bolts and tighten to 10 N·m (89 lb in).



7. Install the EVAP line to the retainer.
8. Install the fuel/brake line push in retainer to the underbody.



9. Install the EVAP line to the retainer.
10. Install the fuel/brake line retainer bolt and tighten to 10 N·m (89 lb in).
11. Lower the vehicle.



12. Install the EVAP line to the fuel/brake pipe retainers (1).
13. Close the fuel/brake pipe retainers (1).



14. Connect the EVAP (2) line to the purge solenoid. Refer to Plastic Collar Quick Connect Fitting Service.
15. Position and install the brake master cylinder. Refer to Master Cylinder Replacement.