GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

  1. Remove the steering column filler panel. Refer to Steering Column Opening Filler Replacement
  2. Remove the accessory trim plate, in not equipped with a front floor console. Refer to Instrument Panel Accessory Trim Plate Replacement
  3. Pull back the front floor console, if equipped. Refer to Front Floor Console Replacement

  4. Object Number: 326097  Size: SH
  5. Remove the instrument panel (IP) access opening covers from the IP.
  6. Open the IP compartment door.
  7. Remove the right lower IP trim plate. Refer to Instrument Panel Trim Panel Replacement - Right Side .

  8. Object Number: 689927  Size: SH
  9. Remove the screw from right end of the IP cluster trim plate.

  10. Object Number: 689931  Size: SH
  11. Release the retainer tab on the right end of the IP cluster trim plate.
  12. Tilt the steering column to the lowest position.
  13. Pull the IP cluster trim plate at the right edge, working towards the left slowly, in order to release the retaining clips.
  14. Remove the IP cluster trim plate from the lP.

Installation Procedure

  1. Position the instrument panel (IP) cluster trim panel cluster trim plate to the IP.
  2. Install the IP cluster trim plate pressing in at each retainer clip location until fully seated.
  3. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.


    Object Number: 689927  Size: SH
  4. Install the screw to right end of the IP cluster trim plate.
  5. Tighten
    Tighten the IP cluster trim plate screw to 2 N·m (18 lb in).

  6. Install the right lower IP trim plate. Refer to Instrument Panel Trim Panel Replacement - Right Side .
  7. Return the steering column to the original position.

  8. Object Number: 326097  Size: SH
  9. Install the IP access hole covers to the instrument panel pressing into place until fully seated.
  10. Close the IP compartment door.
  11. Install the accessory trim plate, in not equipped with a front floor console. Refer to Instrument Panel Accessory Trim Plate Replacement
  12. Install the front floor console, if equipped. Refer to Front Floor Console Replacement
  13. Install the steering column filler panel. Refer to Steering Column Opening Filler Replacement