Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Did you perform the Instrument Cluster Diagnostic System Check? | -- | Go to Step 2 | |
2 |
Does the Low Washer Fluid Input Data match the Driver Information Center Warning message? | -- | Go to Step 4 | Go to Step 3 |
3 | Replace the instrument panel cluster (IPC). Refer to one of the following procedures: Is the replacement complete? | -- | -- | |
4 |
Does the Low Washer Fluid indicator illuminate? | -- | Go to Step 5 | Go to Step 6 |
5 | Inspect the washer fluid level switch connector for proper terminal contact at terminals A and B. Is the contact good? | -- | Go to Step 7 | Go to Step 8 |
6 |
Does the resistance match the specified value? | 0 ohms | Go to Step 9 | Go to Step 10 |
7 | Replace the washer fluid level switch. Is the replacement complete? | -- | -- | |
8 | Repair any poor contacts at the washer fluid level switch connector. Is the repair complete? | -- | -- | |
9 | Inspect the instrument cluster connector (UB3) for proper terminal contact at terminal A11 or connector C1 (U50 or U2F) for proper terminal contact at terminal A16 Are the connections OK? | -- | Go to Step 11 | Go to Step 12 |
10 | Inspect CKT 99 (BLK/WHT) for an open or short to the battery. Is the wiring OK? | -- | Go to Step 13 | Go to Step 14 |
11 | Replace the instrument cluster. Is the replacement complete? | -- | -- | |
12 | Repair any poor terminal contacts. Is the repair complete? | -- | -- | |
13 | Inspect CKT 1150 (BLK) for an open. Is the wiring OK? | -- | Go to Step 15 | Go to Step 16 |
14 | Repair the open or short to the battery. Is the repair complete? | -- | -- | |
15 | Inspect connector C200 for proper terminal contact at terminal L11. Is the connection OK? | -- | Go to Step 12 | |
16 | Repair any open in CKT 1150 (BLK). Is the repair complete? | -- | -- |
