For 1990-2009 cars only
Removal Procedure
- Disable the SIR system. Refer to Disabling the SIR System in SIR.
- Remove the front bucket seat. Refer to Front Seat Replacement - Bucket .
- Remove the seat cushion frame. Refer to Front Seat Cushion Frame Replacement .
- If the cable is equipped with a position sensor, remove the sensor retention clip and disconnect the electrical connector.
- Squeeze the collar of the cable in order to release the cable.
- Pull the cable out of the fitting until the cable end clears the fitting.
- Remove the cable or cable/sensor assembly.
Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:
• Air bag deployment • Personal injury
In order to avoid the above conditions, observe the following guidelines:
• Unnecessary SIR system repairs • Refer to SIR Component Views in order to determine if you are performing service on or near the SIR components or the SIR wiring. • If you are performing service on or near the SIR components or the SIR wiring, disable the SIR system. Refer to Disabling the SIR System.
Installation Procedure
- Install the cable or cable/sensor assembly by pushing the ends into the fittings until the clip snaps into place.
- If the cable is equipped with a position sensor, install the sensor retention clip and connect the electrical connector.
- Install the seat cushion frame. Refer to Front Seat Cushion Frame Replacement .
- Install the front bucket seat. Refer to Front Seat Replacement - Bucket .
- Enable the SIR system. Refer to Enabling the SIR System in SIR.
