For 1990-2009 cars only
- If installing a NEW starter transfer the cables from the old starter.
- Install the positive battery cable to the starter motor stud.
- Install the starter motor stud nut (1). Tighten the starter motor stud nut (1) to 9.5 N·m (84 lb in).
- Install the solenoid wiring harness to the starter solenoid stud.
- Install the starter solenoid stud nut (2). Tighten the starter solenoid stud nut (2) to 3.4 N·m (30 lb in).
- Place the starter motor in position in the engine valley.
- Install the two starter motor bolts and tighten to 30 N·m (22 lb ft).
- Install a NEW O-ring onto the camshaft position (CMP) sensor.
- Lubricate the O-ring with clean engine oil.
- Install the CMP sensor.
- Install the CMP sensor bolt and tighten to 10 N·m (89 lb in).
- Install a NEW O-ring onto the crankshaft position (CKP) sensor.
- Lubricate the O-ring with clean engine oil.
- Install the CKP sensor.
- Install the CKP sensor bolt and tighten to 10 N·m (89 lb in).
- Install the knock (KS) sensors and tighten to 20 N·m (15 lb ft).
- Install the crankshaft position sensor wiring harness into the engine valley.
- Connect the crankshaft position sensor wiring harness to the KS sensors (1).
- Connect the crankshaft position sensor wiring harness to the CKP sensor (2).
- Connect the crankshaft position sensor wiring harness (1) to the CMP sensor.
- Install the jumping ground bracket bolt (2) to the right cylinder head. Tighten the jumping ground bracket bolt (2) to 20 N·m (15 lb ft).
Caution: Refer to Fastener Caution in the Preface section.
