Special Tools

J 45059 Angle Meter

1. Remove the engine front cover. Refer to Engine Front Cover Replacement.



2. Remove the 3 oil pump assembly retaining bolts (1, 2, 3) identified by the larger head size.
3. Slide the oil pump assembly off the nose of the crankshaft with the drive collar in place.
4. Clean and inspect the oil pump. Refer to Oil Pump Cleaning and Inspection.

1. Install the oil pump drive spacer into the oil pump so that the drive flat engages the pump rotor.
2. Position the oil pump on the crankshaft.
3. Install the retaining bolts.

Caution: Refer to Fastener Caution in the Preface section.

4. Apply upward pressure on the pump while tightening the three retaining bolts. Tighten the bolts in the sequence (1, 2, 3) shown.

Tighten

•	First Pass

Tighten the oil pump mounting bolts in sequence to 10 N·m (89 lb in).

•	Final Pass

Tighten the oil pump mounting bolts in sequence an additional 35 degrees using the J 45059 .

5. Install the engine front cover. Refer to Engine Front Cover Replacement.