Special Tools

J 44212 Camshaft Holding Tool

1. Remove the left secondary camshaft drive chain tensioner. Refer to Secondary Camshaft Drive Chain Tensioner Replacement - Left Side.
2. Remove the left camshaft cover. Refer to Camshaft Cover Replacement - Left Side.



3. Ensure both camshaft sprocket drive pins are at the top of their rotation.




Warning: The camshaft holding tools must be installed on the camshafts to prevent camshaft rotation. When performing service to the valve train and/or timing components, valve spring pressure can cause the camshafts to rotate unexpectedly and can cause personal injury.

4. Install the J 44212 over the camshafts.

Caution: Refer to Torque Reaction Against Timing Drive Chain Caution in the Preface section.




5. Use an open end wrench on the hex cast into the camshaft in order to prevent the camshaft from rotating when removing the camshaft sprocket bolt.



6. Remove the left exhaust camshaft sprocket bolt.
7. Slide the left exhaust camshaft sprocket off of the camshaft and remove the left secondary drive chain from the camshaft sprocket teeth.



8. Remove the left secondary camshaft drive chain guide access plug (4) located in the cylinder head. Ensure the O-ring seal remains attached to the access plug.



9. Remove the upper left secondary camshaft drive chain guide bolt.



10. Remove the lower left secondary camshaft drive chain guide bolt.



11. Remove the left secondary camshaft drive chain guide.
12. Clean and inspect the camshaft timing drive components. Refer to Camshaft Timing Drive Components Cleaning and Inspection.

1. Position the left secondary camshaft drive chain guide in through the top of the cylinder head.



2. Loosely install the lower left secondary camshaft drive chain guide bolt.

Caution: Refer to Fastener Caution in the Preface section.




3. Install the upper left secondary camshaft drive chain guide bolt.

Tighten
Tighten the secondary camshaft drive chain guide bolts to 25 N·m (18 lb ft).




4. Install the left secondary camshaft drive chain guide access plug (4) located in the cylinder head. Ensure the O-ring seal is attached to the access plug.

Tighten
Tighten the secondary camshaft drive chain guide access plug to 4.5 N·m (40 lb in).




5. Install the left exhaust camshaft sprocket into the left secondary camshaft drive chain.
6. Install the left exhaust camshaft sprocket onto the camshaft. The camshaft sprocket notch marked LE (left exhaust) engages the exhaust camshaft pin.

Caution: Refer to Torque Reaction Against Timing Drive Chain Caution in the Preface section.




7. Use an open end wrench on the hex cast into the camshaft in order to prevent the camshaft from rotating when tightening the camshaft sprocket bolt.



8. Install the left exhaust camshaft sprocket bolt.

Tighten
Tighten the camshaft sprocket bolt to 120 N·m (89 lb ft).




9. Remove the J 44212 from the camshafts.
10. Install the left camshaft cover. Refer to Camshaft Cover Replacement - Left Side.
11. Install the left secondary camshaft drive chain tensioner. Refer to Secondary Camshaft Drive Chain Tensioner Replacement - Left Side.