Circuit Description
The instrument cluster turns the ABS indicator ON during the instrument cluster bulb check for approximately 3 seconds when the ignition switch is turned to the RUN position. If the EBCM/EBTCM sets a DTC, the EBCM/EBTCM sends the instrument cluster the command to turn the ABS indicator ON.
Test Description
The numbers below refer to step numbers on the diagnostic table.
Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
DEFINITION: The ABS indicator does not come ON during the instrument cluster bulb check. | ||||
1 | Was the ABS Diagnostic System Check performed? | -- | Go to Step 2 | |
Using a scan tool in ABS/TCS Special Functions, attempt to turn the ABS indicator ON. Did the ABS indicator turn ON? | -- | Go to Step 3 | Go to Step 4 | |
3 | Replace the EBCM/EBTCM. Refer to Electronic Brake Control Module Replacement . Is the repair complete? | -- | -- | |
4 | Replace the instrument cluster. Refer to Instrument Cluster Replacement in Instrument Panel, Gauges and Console. Is the repair complete? | -- | -- | |
