GM Service Manual Online
For 1990-2009 cars only

Step

Action

Value(s)

Yes

No

1

Did you perform the Instrument Cluster Diagnostic System Check?

--

Go to Step  2

Go to Diagnostic System Check - Instrument Cluster

2

  1. Disconnect the left front door jamb switch connector.
  2. Turn the ignition switch to the RUN position.
  3. Use a J 39200 DMM in order to measure the voltage between connector terminal B (GRY/BLK) and ground.

Is the measured voltage within the specified range?

10-15 V

Go to Step  8

Go to Step  3

3

Inspect CKT 745 (GRY/BLK) for an open or short to ground.

Is the wiring OK?

--

Go to Step  5

Go to Step  4

4

Repair the open or short to ground in CKT 745 (GRY/BLK).

Did you complete the repair?

--

Go to Instrument Cluster System Check

--

5

Inspect the instrument cluster connector C2 and terminal B9 for proper terminal contact.

Are the terminal contacts OK?

--

Go to Step  7

Go to Step  6

6

Repair the poor terminal contact.

Did you complete the repair?

--

Go to Instrument Cluster System Check

--

7

Replace the instrument cluster. Refer to Instrument Cluster Replacement.

Did you complete the repair?

--

Go to Instrument Cluster System Check

--

8

Use a J 39200 DMM in order to measure the voltage between the left front door latch assembly connector terminal B (GRY/BLK) and terminal D (BLK/WHT).

Is the voltage within the specified range?

10-15 V

Go to Step  11

Go to Step  9

9

Inspect CKT 151 (BLK/WHT) for an open.

Is the wiring OK?

--

Go to Instrument Cluster System Check

Go to Step  10

10

Repair the open on CKT 151 (BLK/WHT).

Did you complete the repair?

--

Go to Instrument Cluster System Check

--

11

Inspect the left front door latch assembly for proper terminal contact.

Is the terminal contact OK?

--

Go to Step  12

Go to Step  6

12

Replace the left door latch assembly.

Did you complete the repair?

--

Go to Instrument Cluster System Check

--