Removal Procedure
- Remove the door trim panel. Refer to
Rear Side Door Trim Panel Replacement
.
- Remove the trim panel bracket fasteners.
- Remove the trim panel bracket.
- Use the J 38778
in
order to remove the push in fasteners at the outer top edges of the water
deflector.
- Remove the water deflector (3) by peeling the deflector off the
door inner panel.
Installation Procedure
- Install the water deflector (3)
over the inside handle.
Notice: Proper sealing is necessary in order to prevent water entry into the
door and possible damage to inner door components.
- Align the water deflector with the top of the inner door panel.
Apply pressure to the deflector in order to hold the deflector in position.
- Carefully guide the wire harness through the slits in the water
deflector.
- Insert the extruded pockets as required. Remove any wrinkles.
- Secure the bottom center. Work forward and up.
- Return to the bottom center. Work the seal rearward and up.
- Install the trim panel bracket.
- Install the three fasteners.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the three fasteners to 9 N·m (80 lb in).
- Install the trim panel. Refer to
Rear Side Door Trim Panel Replacement
.