The powertrain control module (PCM) uses the 5 Volt Reference A circuit as a sensor feed to the following sensors:
• | The TP sensor |
• | The MAP sensor |
• | The EGR valve pintle position sensor |
The PCM monitors the voltage on the 5 Volt Reference A circuit. If the voltage is out of tolerance. DTC P1635 will set.
• | The PCM detects a voltage out of tolerance condition on the 5 Volt Reference A circuit. |
• | The above condition is present for longer than 10 seconds. |
• | The PCM will illuminate the malfunction indicator lamp (MIL) during the second consecutive trip in which the diagnostic test has been run and failed. |
• | The PCM will store conditions which were present when the DTC set as Freeze Frame/Failure Records data. |
• | The PCM will turn OFF the malfunction indicator lamp (MIL) during the third consecutive trip in which the diagnostic has run and passed. |
• | The history DTC will clear after 40 consecutive warm-up cycles have occurred without a malfunction. |
• | The DTC can be cleared by using a scan tool. |
Important:: Be sure to inspect PCM and engine grounds for being secure and clean.
Inspect for the following conditions:
Many situations may lead to an intermittent condition. Perform each inspection or test as directed.
Important: : Remove any debris from the connector surfaces before servicing a component. Inspect the connector gaskets when diagnosing or replacing a component. Ensure that the gaskets are installed correctly. The gaskets prevent contaminate intrusion.
• | Loose terminal connection |
- | Use a corresponding mating terminal to test for proper tension. Refer to Testing for Intermittent Conditions and Poor Connections , and to Connector Repairs in Wiring Systems for diagnosis and repair. |
- | Inspect the harness connectors for backed out terminals, improper mating, broken locks, improperly formed or damaged terminals, and faulty terminal to wire connection. Refer to Testing for Intermittent Conditions and Poor Connections , and to Connector Repairs in Wiring Systems for diagnosis and repair. |
• | Damaged harness--Inspect the wiring harness for damage. If the harness inspection does not reveal a problem, observe the display on the scan tool while moving connectors and wiring harnesses related to the sensor. A change in the scan tool display may indicate the location of the fault. Refer to Wiring Repairs in Wiring Systems for diagnosis and repair. |
• | Inspect the powertrain control module (PCM) and the engine grounds for clean and secure connections. Refer to Wiring Repairs in Wiring Systems for diagnosis and repair. |
If the condition is determined to be intermittent, reviewing the Snapshot or Freeze Frame/Failure Records may be useful in determining when the DTC or condition was identified.
The numbers below refer to the step numbers on the diagnostic table.
Step | Action | Values | Yes | No |
---|---|---|---|---|
1 | Did you perform the Powertrain On Board Diagnostic (OBD) System Check? | -- | ||
2 |
Did you find and correct the condition? | -- | ||
3 |
Is voltage near the specified value indicated? | 5 V | ||
4 | Is voltage near the specified value indicated? | 0 V | ||
5 |
Is voltage near the specified value indicated? | 5 V | ||
6 |
Was a component replaced? | -- | ||
7 |
Did you find and correct the condition? | -- | ||
8 |
Did you find and correct the condition? | -- | ||
9 | Replace the EGR valve. Refer to Exhaust Gas Recirculation Pipe Replacement . Is the action complete? | -- | -- | |
Important:: The replacement PCM must be programmed. Replace PCM. Refer to Powertrain Control Module Replacement/Programming . Is the action complete? | -- | -- | ||
11 |
Does the scan tool indicate DTC P1635 failed this ignition? | -- | System OK |