Removal Procedure
- Disconnect brake pipes
from the master cylinder.
- Disconnect fluid level sensor electrical connector.
- Remove master cylinder mounting nuts (1).
- Remove the master cylinder.
- Drain the master cylinder reservoir of all brake fluid.
- Remove the master cylinder reservor. Refer to
Master Cylinder Reservoir Replacement
.
Installation Procedure
- Install the master cylinder
reservoir. Refer to
Master Cylinder Reservoir Replacement
.
- Install the master cylinder.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the master
cylinder mounting nuts (1).
Tighten
Tighten the brake booster mounting nuts to 25 N·m (18 lb ft).
- Connect the fluid level sensor electrical connector.
- Connect the brake pipes to the master cylinder.
Tighten
Tighten the master cylinder tube nuts to 15 N·m (11 lb ft).
- Fill the master cylinder reservoir with brake fluid. Refer to
Master Cylinder Reservoir Filling
.
- Bleed the brake system. Refer to
Hydraulic Brake System Bleeding
.