Important: 

This master cylinder is a composite design with a plastic reservoir (9) and an aluminum body (11). The master cylinder is used in a diagonally split system. In this system, one front and one diagonally rear brake is served by the primary piston (17), and the opposite front and rear brakes are served by the secondary piston (15).

The master cylinder incorporates the functions of a standard dual master cylinder. The master cylinder also has a fluid level sensor (8) and integral proportioning.The proportioning valves are designed to provide better front-to-rear braking balance with a heavy brake application.

Important: Do not wash the proportioning valve in any cleaning solution. The internal components are prelubricated with a special grease.

The proportioning valves are threaded into the brake lines (in line) at the rear of the vehicle. The proportioning valves proportion the brake fluid to each caliper or wheel cylinder after a predetermined amount of pressure is reached. The proportioner valves limit outlet pressure to the rear brakes after the brakes meet a predetermined inlet pressure. The proportioning valves limit pressure when less apply force is needed in order to obtain optimum breaking.The proportional valves prevent rear wheel lock-up on vehicles that do not have heavy rear wheel loads.

The compact master cylinders are equipped with a fluid level sensor. The sensor switch is located in the inboard side of the reservoir. The sensor activates the BRAKE warning lamp if the fluid level is low. The BRAKE warning lamp turns off when the fluid level is corrected. For electrical details on the BRAKE warning system, Refer to Brake Warning System Check Brake Warning System in Electrical Diagnosis.

The anti-lock brake system uses a amber ANTI-LOCK lamp indicator lamp.

The lamp is located in the instrument panel cluster. Ensure that the lamp exhibits the following conditions under normal conditions:

Caution: Brake fluid may irritate eyes and skin. In case of contact, take the following actions:

Caution: Use only Delco Supreme 11, GM P/N 12377967 (Canadian P/N 992667), or equivalent DOT 3 brake fluid from a clean, sealed container. Do not use fluid from an open container that may be contaminated with water. Improper or contaminated fluid could result in damage to components, or loss of braking, with possible injury.

Notice: Avoid spilling brake fluid on any of the vehicle's painted surfaces, wiring, cables, or electric connectors. Brake fluid will damage the paint and the electrical connections. If any fluid is spilled on the vehicle, flush the area to lessen the damage.

Important: 

1. Do not use power steering fluid or transmission fluid in the brake system.
2. Do not re-use brake fluid that has accumulated during the brake system bleeding.
3. Store brake fluid in a closed container. Reseal the brake fluid containers immediately after use. Do not use brake fluid in an open or improperly sealed container because the fluid absorbs moisture or may become contaminated.

The following conditions may cause the fluid to boil:

If the rubber parts are deteriorated, the following parts will be swollen:

Disassemble all of the serviceable hydraulic components if deterioration exists. Wash all of the parts with alcohol. Dry the parts with non-lubricated compressed air in order to keep the alcohol out of the system. Replace all of the rubber parts in the system, including the hoses and the non-serviceable hydraulic components.

Refill the brake system with new brake fluid. Refer to Master Cylinder Reservoir Filling .

Flush the brake system. Refer to Hydraulic Brake System Flushing .

Bleed the brake system. Refer to Hydraulic Brake System Bleeding .