Removal Procedure
- Remove the seat headrest for clearance. Refer to
Front Seat Head Restraint Replacement
.
- Remove the adjuster track covers. Refer to
Front Seat Adjuster Track Finish Cover Replacement
.
- Operate the seat in the full forward to the mid-position and the
full up position.
- Remove the two seat adjuster
to the floor pan bolts, located at the rear of the seat.
- Tip the seat forward and remove the front seat retractor side
belt anchor nut. Refer to the following procedures:
- Disconnect the power seat electrical connector if equipped.
- Disengage the front bucket seat hook attachments from the floor
pan.
- Remove the front seat from the vehicle.
Installation Procedure
- Position the front seat in the vehicle.
- Tip the seat forward and
engage the front hook attachments.
- Connect the seat belt reminder electrical connector on the driver's
side only.
- Install the power seat electrical connector if equipped.
- Install the seat retractor side belt to the front seat. Refer
to the following procedures:
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the seat adjuster-to-floor pan
bolts.
Tighten
Tighten the seat adjuster to floor pan bolts to 42 N·m
(31 lb ft).
- Install the adjuster track covers. Refer to
Front Seat Adjuster Track Finish Cover Replacement
.
- Install the seat headrest. Refer to
Front Seat Head Restraint Replacement
.
- Inspect the front bucket seat for proper operation and adjustment.