GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Buick 🢒 2006 🢒 Rendezvous - FWD 🢒 Body 🢒 Wiring Systems 🢒 Camshaft Position Sensor Replacement

Removal Procedure

    Object Number: 1641074 Size: SH
  1. Remove the power steering pump. Refer to Power Steering Pump Replacement .
  2. Disconnect the fuel injector harness electrical connector from the camshaft position (CMP) sensor.

    3. Object Number: 1646078 Size: SH
  3. Remove the CMP sensor bolt.
  4. Remove the CMP sensor.
  5. Inspect the CMP sensor O-ring for wear or damage if the sensor is not being replaced, replace the seal as necessary.

Installation Procedure

    Object Number: 1646078 Size: SH
  1. Lubricate the sensor O-ring with clean engine oil.
  2. Remove the CMP sensor.

    3. Notice: Refer to Fastener Notice in the Preface section.

  3. Remove the CMP sensor bolt.

    4. Tighten
    Tighten the bolt to 10 N·m (89 lb ft).


    Object Number: 1641074 Size: SH
  4. Connect the fuel injector harness electrical connector to the CMP sensor.
  5. Install the power steering pump. Refer to Power Steering Pump Replacement .