GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Buick 🢒 2007 🢒 Rendezvous - FWD 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Body Control Module Replacement

Removal Procedure

    Important: You must perform the new body control module (BCM) setup when replacing the BCM. Refer to Body Control Module Programming and Setup .

  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the console accessory wiring junction block. Refer to Console Electrical Center or Junction Block Replacement .

    3. Object Number: 627744 Size: SH
  3. Rotate the BCM retaining lever (1) to release the BCM from the console accessory wiring junction block.
  4. Remove the BCM (2) from the console accessory wiring junction block.

Installation Procedure

    Object Number: 627743 Size: SH

    Important:  Align the BCM to the console accessory wiring junction block.

  1. Install the BCM (1) onto the console accessory wiring junction block.
  2. Rotate the BCM retaining lever (2) to secure the BCM to the console accessory wiring junction block.
  3. Install the console accessory wiring junction block. Refer to Console Electrical Center or Junction Block Replacement .
  4. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  5. Perform the new BCM setup. Refer to Control Module References for programming and setup information.