The body control module (BCM) controls the shift lock solenoid by providing battery voltage to the shift lock control solenoid. The BCM utilizes a smart driver to control the voltage supplied to the shift lock solenoid. The smart driver monitors the voltage and current flow of the control circuit.

Schematic Reference

Shift Lock Control Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

Automatic Transmission Shift Lock Control Description and Operation

Electrical Information Reference

Scan Tool Reference

Control Module References for scan tool information

1. Ignition ON, with the brake pedal applied, observe the scan tool Brake Applied Output Signal parameter. The reading should be ON with the brake pedal depressed and released.

⇒	If not the specified parameter, refer to Stop Lamps Malfunction.

2. Press the brake pedal, the vehicle operator should be able to move the shifter lever out of the PARK position.

1. Ignition OFF, disconnect the harness connector at the automatic transmission shift lock actuator.
2. Test for less than 1.0 Ω between the ground circuit terminal K and ground.

⇒	If greater than the specified range, test the ground circuit for an open/high resistance.

3. Connect a test lamp between the control circuit terminal E and ground.
4. Ignition ON, command the scan tool BCM shift lock solenoid output control ON and OFF. The test lamp should turn ON and OFF as commanded.

⇒	If the test lamp is always ON, test the control circuit for a short to voltage. If circuit test normal, replace the BCM.

⇒	If the test lamp is always OFF, test the control circuit for a short to ground or an open/high resistance. If circuits test normal, replace the BCM.

5. If all circuits test normal, test or replace the shift lock actuator.

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.