Preliminary Procedures

1. Position the rear door window approximately half way down in the door.
2. Remove the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement.
3. Remove the rear door water deflector. Refer to Rear Side Door Water Deflector Replacement.
4. Tape the window to the door frame to prevent it from moving.
5. Remove the rear door window regulator. Refer to Rear Side Door Window Regulator Replacement.
6. Refer to Control Module References for replacement and setup information.

1

Rear Door Window Regulator Motor Screw (Qty: 3)

Caution: Refer to Fastener Caution in the Preface section.

Tighten
4.6 N·m (41 lb in)

2

Rear Door Window Regulator Motor

Tip
Disconnect the electrical connector from the window regulator motor.