Removal Procedure
Caution: Refer to SIR Caution in the Preface section.
- Disable the SIR system. Refer to
SIR Disabling and Enabling
in SIR.
- Remove the steering column trim covers. Refer to
Steering Column Trim Covers Replacement
.
- Remove the theft deterrent
module (2) from the ignition lock cylinder case assembly (1).
- Disconnect the ignition switch electrical connector.
- Remove the key alarm connector (1)
from the ignition lock cylinder case (4).
- Remove the ignition switch retaining screws (3).
- Remove the lower case ignition switch (2).
Installation Procedure
- Install the lower case
ignition switch (2) to the steering column.
Notice: Refer to Fastener Notice in the Preface section.
- Install the ignition switch retaining screws (3).
Tighten
Tighten the screws to 1.5 N·m (13 lb in).
- Connect the ignition switch electrical connectors.
- Install the theft deterrent
module (2) to the ignition lock cylinder case (1).
- Install the steering column trim covers. Refer to
Steering Column Trim Covers Replacement
.
- Enable the SIR system. Refer to
SIR Disabling and Enabling
in SIR.