Removal Procedure
- Open the door.
- Remove the door trim panel. Refer to
Rear Side Door Trim Panel Replacement
.
- Remove the door module. Refer to
Door Control Module Replacement
.
- Remove the water deflector. Refer to
Rear Side Door Water Deflector Replacement
.
- Remove the check link
to pillar bolt.
- Note the position of the
arrow on the check link arm to aid in reassembly.
- Remove the 2 nuts from the door check link.
- Remove the check link through the front access hole of the inner
door panel.
Installation Procedure
- Install the check link
into the door. Ensure the arrow on the check link arm is positioned as noted
during removal.
- Load the check link studs through the access hole in the inner
panel.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the check
link nuts.
Tighten
Tighten the nuts to 9 N·m (80 lb in).
- Position the check link
arm to the center pillar.
- Install the check link to pillar bolt.
Tighten
Tighten the check link arm bolt to 25 N·m (18 lb ft).
- Install the water deflector. Refer to
Rear Side Door Water Deflector Replacement
.
- Install the door module. Refer to
Door Control Module Replacement
.
- Install the door trim panel. Refer to
Rear Side Door Trim Panel Replacement
.