GM Service Manual Online
For 1990-2009 cars only

Radio Front Speaker Replacement IP

Removal Procedure


    Object Number: 585318  Size: SH
  1. Remove the instrument panel upper trim panel. Refer to Instrument Panel Upper Trim Pad Replacement in Instrument Panel, Gages and Console.
  2. Remove the electrical connector hold down from the IP pad
  3. Remove the fasteners  (1) from the speaker (2) to be serviced.
  4. Remove the speaker (2) from the IP top pad.

Installation Procedure


    Object Number: 585318  Size: SH
  1. Align the speaker (2) to be replaced to the opening in the instrument panel upper trim panel.
  2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the fasteners (1).
  4. Tighten
    Tighten the fasteners (1) to 2.5 N·m (22 lb in).

  5. Secure the electrical connector to the IP pad, with the attached edge clip.
  6. Install the instrument panel upper trim panel. Refer to Instrument Panel Upper Trim Pad Replacement in Instrument Panel, Gages and Console.