Removal Procedure
Caution: Refer to SIR Caution in the Preface section.
- Disable the SIR system. Refer to
SIR Disabling and Enabling
in SIR.
- Slide the shift lever seal (2) up the shift lever (4).
- If necessary, remove the steering column trim covers. Refer to
Steering Column Trim Covers Replacement
.
- Disconnect the shift lever connector at the base of the column.
- Remove the shift lever screw (3) from the shift lever assembly (4).
- Remove the shift lever and seal from the linear shift assembly.
Important: The shift lever seal must be removed by sliding the shift lever seal towards the narrow section of the shift lever.
- Remove the shift lever seal (2) from the shift lever (4).
Installation Procedure
Important: The shift lever seal must be installed to the narrow end of the shift lever.
- Install the shift lever seal (2) onto the shift lever assembly (4).
- Install the shift lever assembly (4) to linear shift assembly.
Notice: Refer to Fastener Notice in the Preface section.
- Install the shift lever screw (3) into the shift lever assembly (4).
Tighten
Tighten the screw to 20 N·m (15 lb ft).
- Slide the shift lever seal (2) down the shift lever assembly (4).
- Align the shift lever seal into the steering column trim covers.
- If necessary, install the steering column trim covers. Refer to
Steering Column Trim Covers Replacement
.
- Enable the SIR system. Refer to
SIR Disabling and Enabling
in SIR.