GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2002 🢒 Eldorado 🢒 Body and Accessories 🢒 Doors 🢒 Outside Rearview Mirror Motor Replacement

Removal Procedure
  1. Remove the trim panel. Refer to Door Trim Panel Replacement
  2. Remove the water deflector. Refer to Door Water Deflector Replacement
  3. Disconnect the electrical connector (4).

    4. Object Number: 443159 Size: SH
  4. Remove the mirror assembly fasteners (3).
  5. Carefully guide the electrical harness through the door from between the inner panel and the impact bar.
  6. Remove the mirror assembly (2) from the door.

Installation Procedure

    Object Number: 443159 Size: SH
  1. Carefully route the electrical harness through the door in between the inner panel and side impact bar.
  2. Install the mirror assembly (2) to the door.
  3. The mirror must be parallel to the edge of the mucket within 2 mm.

    4. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  4. Install the fasteners (3) that secure the mirror to the door.

    5. Tighten

        • Tighten the 2 bottom nuts first to 6 N·m (53 lb in).
        • Tighten the top nut last to 6 N·m (53 lb in).
  5. Connect the electrical connector (4).
  6. Install the water deflector. Refer to Door Water Deflector Replacement
  7. Install the trim panel. Refer to one Door Trim Panel Replacement