Diagnostic Aids
If the sunroof is experiencing an intermittent inoperative condition, check the sunroof switch ground circuit for an open. If the sunroof switch ground circuit is open, the switch may take a redundant path to ground through the switch illumination circuit. When the lights are turned On, the redundant path to ground is removed. The sunroof may become inoperative.
A short to voltage in any one of the sunroof switch signal circuits will most likely open the switch.
By performing sunroof control module circuit tests at the inline harness connectors behind the right rear sail panel, may prevent the removal of the headliner.
Test Description
The numbers below refer to the step numbers on the diagnostic table.
-
This step tests the integrity of the ground circuit of the sunroof switch. If the switch illuminates when the headlamps are turned ON, the switch ground circuit is OK. Also, turning on the headlamps eliminates the possibility of the switch finding an alternative path to ground through the illumination circuit.
-
This step tests the integrity sunroof switch, if the roof operates when performing this test, the switch is at fault. If the fuse in the jumper wire opens when you perform this test, a short to battery voltage may have occurred.
-
This step tests for voltage in the battery positive voltage circuit at the inline connector.
-
This step tests the integrity of the sunroof enable signal circuit. If the fuse in the jumper wire opens when you perform this test, a short to battery voltage may have occurred.
Step | Action | Values | Yes | No |
|---|---|---|---|---|
Schematic Reference: Sunroof Schematics Connector End View Reference: Sunroof Connector End Views DEFINITION: All functions of the power sunroof system are inoperative. | ||||
1 | Have you conducted diagnostic system check- vehicle? | -- | Go to Step 2 | |
2 | Attempt to operate the power sunroof through its full range of functions in order to verify that the power sunroof inoperative fault is present. Does the Power Sunroof System operate normally? | -- | Go to Testing for Intermittent Conditions and Poor Connections | Go to Step 3 |
Does the sunroof switch illuminate? | -- | Go to Step 4 | Go to Step 8 | |
Did the sunroof move in the direction as tested? | -- | Go to Step 12 | Go to Step 5 | |
Does the voltage measure near the specified value? | B+ | Go to Step 6 | Go to Step 17 | |
6 | At the inline harness connector C310, measure the voltage between the battery positive voltage circuit of the sunroof module and the ground circuit of the sunroof module. Does the voltage measure near the specified value? | B+ | Go to Step 7 | Go to Step 18 |
Did the sunroof move in the intended direction? | -- | Go to Step 11 | Go to Step 10 | |
8 | Test the illumination circuit of the sunroof switch for an open. Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition? | -- | Go to Step 22 | Go to Step 9 |
9 | Test the ground circuit of the sunroof switch for an open. Refer to Circuit Testing and Wiring Repairs . Do you find and correct the condition? | -- | Go to Step 22 | Go to Step 14 |
10 | Test the sunroof enable signal circuit between the inline harness connector C310 and the sunroof control module for an open. Refer to Circuit Testing and Wiring Repairs . Do you find and correct the condition? | -- | Go to Step 22 | Go to Step 13 |
11 | Test the sunroof enable signal circuit between the sunroof control module and the rear integration module for a short to battery voltage or an open. Refer to Circuit Testing and Wiring Repairs . Do you find and correct the condition? | -- | Go to Step 22 | Go to Step 16 |
12 | Test all of the sunroof switch signal and express circuits for a short to battery voltage. Refer to Circuit Testing and Wiring Repairs . Do you find and correct the condition? | -- | Go to Step 22 | Go to Step 14 |
13 | Test the battery positive voltage circuit and the ground circuit between the sunroof control module and the inline harness connector C310 for an open. Refer to Circuit Testing and Wiring Repairs . Do you find and correct the condition? | -- | Go to Step 22 | Go to Step 15 |
14 | Inspect for poor connections at the harness connector of the sunroof switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs . Do you find and correct the condition? | -- | Go to Step 22 | Go to Step 19 |
15 | Inspect for poor connections at the harness connectors of the sunroof control module. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs . Do you find and correct the condition? | -- | Go to Step 22 | Go to Step 20 |
16 | Check for poor connections at the harness connector of the rear integration module (RIM). Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs . Do you find and correct the condition? | -- | Go to Step 22 | Go to Step 21 |
17 | Repair the short to ground or open in the battery positive circuit of the sunroof control module. Refer to Wiring Repairs and Connector Repairs . Is the trouble corrected? | -- | Go to Step 22 | -- |
18 | Repair the open in the ground circuit of the sunroof control module. Refer to Wiring Repairs and Connector Repairs . Is the trouble corrected? | -- | Go to Step 22 | -- |
19 | Replace the sunroof switch. Refer to Sunroof Switch Replacement . Have you finished the replacement? | -- | Go to Step 22 | -- |
20 | Replace the sunroof control module. Refer to Control Module References to replace, set and program. Have you finished the replacement? | -- | Go to Step 22 | -- |
21 | Replace the RIM. Refer to Control Module References to replace, set and program. Have you finished the replacement? | -- | Go to Step 22 | -- |
22 | Operate the system to verify the repair. Do you find and correct the condition? | -- | System OK | Go to Step 2 |
