Radio Antenna Module Replacement Passenger Side

1. Remove the rear opening weatherstrip.
2. Remove the rear quarter trim panels. Refer to Body Side Rear Upper Garnish Molding Replacement .
3. Loosen the front quarter trim panels. Refer to Side Door Opening Frame Garnish Molding Replacement .
4. Remove the rear coat hooks.
5. Remove the rear park assist display.
6. Pull the headliner down carefully to access the antenna module.



7. Disconnect the coax cables.
8. Disconnect the electrical connector.
9. Slide the antenna module (1) off the mounting bracket.

1. Install the antenna module (1) to the mounting bracket.
2. Connect all the electrical connectors.
3. Install the headliner. Refer to Headlining Trim Panel Replacement.
4. Install the rear park assist display.

Notice: Refer to Fastener Notice in the Preface section.

5. Install the rear coat hooks.

Tighten
Tighten the fasteners to 10 N·m (88 lb in).

6. Install the front quarter trim panels. Refer to Side Door Opening Frame Garnish Molding Replacement .
7. Install the rear quarter trim panels. Refer to Body Side Rear Upper Garnish Molding Replacement .
8. Install the rear opening weatherstrip.
9. Refer to Control Module References for programming and setup information.

Radio Antenna Module Replacement Driver Side

1. Remove the rear opening weatherstrip.
2. Remove the rear quarter trim panels. Refer to Body Side Rear Upper Garnish Molding Replacement .
3. Loosen the front quarter trim panels. Refer to Side Door Opening Frame Garnish Molding Replacement .
4. Remove the rear coat hooks.
5. Remove the rear park assist display.
6. Pull the headliner down carefully to access the antenna module.



7. Disconnect the coax cables.
8. Disconnect the electrical connector.
9. Slide the radio control module (1) off the mounting bracket.

1. Install the radio control module (1) to the mounting bracket.
2. Connect all the electrical connectors.
3. Install the headliner.
4. Install the rear park assist display.

Notice: Refer to Fastener Notice in the Preface section.

5. Install the rear coat hooks.

Tighten
Tighten the fasteners to 10 N·m (88 lb in).

6. Install the front quarter trim panels. Refer to Side Door Opening Frame Garnish Molding Replacement .
7. Install the rear quarter trim panels. Refer to Body Side Rear Upper Garnish Molding Replacement .
8. Install the rear opening weatherstrip.
9. Reprogram the keyless entry transmitter. Refer to Transmitter Programming.
10. Reprogram the tire pressure sensors. Refer to Tire Pressure Sensor Learn.
11. Refer to Control Module References for programming and setup information.