Removal Procedure
- Remove the steering column trim covers. Refer to
Steering Column Trim Covers Replacement
.
- Tilt the steering column to the CENTER position.
- Disconnect any electrical connectors as needed.
- Remove the turn signal multifunction switch bolts.
- Remove the turn signal multifunction switch from the steering column.
Installation Procedure
- Install the turn signal multifunction switch to the steering column.
Notice: Refer to Fastener Notice in the Preface section.
- Install the turn signal multifunction switch bolts.
Tighten
• | Tighten the top bolt to 3 N·m (27 lb in). |
• | Tighten the front bolt to 7 N·m (62 lb in). |
- Connect any electrical connectors as needed.
- Install the steering column trim covers. Refer to
Steering Column Trim Covers Replacement
.