Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC B3607 4B: Pedals Softstops Not ProgrammedCircuit/System Description
After replacement of adjustable pedal mechanical components or if the memory seat module is reprogrammed or replaced, the adjustable pedals softstop positions must be learned.
Conditions for Running the DTC
The memory seat module must be powered.
Conditions for Setting the DTC
This DTC will set if the pedals actuator softstops are not learned.
Action Taken When the DTC Sets
Manual and memory adjustable pedals operation will be disabled.
Conditions for Clearing the DTC
| • | The current DTC will become a history DTC when the fault is no longer present and the ignition has been cycled. |
| • | The history DTC will clear after 50 consecutive fault-free ignition cycles have occurred. |
Diagnostic Aids
The memory seat module (MSM) may be referenced as the driver position module.
Reference Information
Schematic Reference
Connector End View Reference
Description and Operation
Adjustable Pedals Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
Ignition ON, observe the scan tool Pedals Softstop Learn Status parameter. The parameter reading should be Learned.
Circuit/System Testing
- Ignition ON, verify that no other adjustable pedal DTCs are set.
- Ignition ON, perform the scan tool Learn Pedals Softstops procedure. Refer to Adjustable Pedal System Calibration. The scan tool Pedals Softstop Learn Status parameter should be Learned.
| ⇒ | If other adjustable pedal DTCs are set, diagnosis those DTCs first. |
| ⇒ | If not the specified value replace the memory seat module. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for the MSM replacement, setup, and programming
