Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC P2534: Ignition 1 Switch Circuit Low VoltageCircuit/System Description
The transmission control module (TCM) samples the system voltage on the Ignition 1 voltage circuit every 0.1 seconds. Lower than normal voltage may be inadequate to operate the transmission control solenoids properly. Improper solenoid operation may cause erratic transmission operation, which may result in internal damage.
Conditions for Running the DTC
The engine is running.
Conditions for Setting the DTC
The TCM detects an open or short to ground on the Ignition 1 voltage circuit.
Action Taken When the DTC Sets
| • | DTC P2534 is a Type A DTC. |
| • | The TCM commands maximum line pressure. |
| • | The TCM freezes transmission adaptive functions. |
| • | The TCM turns off power to all solenoids. |
| • | The transmission will operate in fifth gear if the vehicle has successfully completed a 1-2 upshift in the current ignition cycle. If the vehicle has not completed a 1-2 upshift in the current ignition cycle, the transmission will operate in fourth gear. |
| • | The TCM inhibits Powertrain Braking. |
| • | The TCM inhibits Autograde Braking. |
| • | The TCC is disabled. |
| • | The TCM inhibits Torque management. |
Conditions for Clearing the DTC
DTC P2534 is a Type A DTC.
Diagnostic Aids
| • | If all circuit tests are OK, ensure the transmission pass through connector and harness terminals are clean and not damaged, and the charging system is functioning correctly. |
| • | Verify there is a good connection at the body control module (BCM) especially if DTC P0700 is also set with this code. |
Reference Information
Schematic Reference
Automatic Transmission Controls Schematics
Connector End View Reference
Description and Operation
Transmission General Description
Electrical Information Reference
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions
Scan Tool Reference
Transmission Control Module Scan Tool Information
Circuit/System Testing
Test the ignition 1 voltage circuit of the TCM for an open or short to ground.
Refer to Control Module References for replacement, setup, and programming.
Repair Instructions
Perform the Diagnostic Repair Verification after completing the repair.
Control Module References for TCM replacement, setup, and programming
