Removal Procedure
- If equipped with 2 wheel drive (2WD), remove the drive flange (2) and seal (3). Refer to
Drive Flange and Seal Replacement
.
- Place a suitable jack under the transmission pan in order to support the transmission.
- Remove the transmission support. Refer to
Transmission Support Replacement
.
- If equipped with all wheel drive (AWD), remove the transfer case. Refer to
Transfer Case Assembly Replacement
.
- Place a drain pan under the extension housing.
- Remove the extension housing bolts (35).
- Remove the extension housing (27) and seal (25).
- If equipped with AWD, remove the seal from the extension housing.
Installation Procedure
- If equipped with AWD, install a NEW seal to the extension housing.
Important: The case extension gasket seal is reusable. Replace the gasket ONLY if the sealing surface is damaged.
- Install the extension housing (27) and seal (25).
Notice: Refer to Fastener Notice in the Preface section.
- Install the extension housing bolts (35).
Tighten
Tighten the bolts to 22 N·m (16 lb ft).
- If equipped with AWD, remove the transfer case. Refer to
Transfer Case Assembly Replacement
.
- Install the transmission support. Refer to
Transmission Support Replacement
.
- Remove the transmission jack.
- If equipped with 2WD, install the drive flange (2) and seal (3). Refer to
Drive Flange and Seal Replacement
.