Tools Required

J 45012 Holding Fixture

1. Install the NEW output shaft assembly retainer (30).
2. Install the NEW prop shaft flange o-ring seal (32) into the prop shaft flange (31).
3. Install the prop shaft flange (31).
4. Put the transmission in Park.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

5. Install the NEW prop shaft flange thrust washer (33) and NEW prop shaft flange nut (34) using GM P/N 89021297.
6. Using J 45012 , tighten the prop flange nut.

Tighten
Tighten the prop shaft flange nut (34) to 57 N·m (42 lb ft).