Tools Required
J 21854-01
Pivot Pin Remover
Removal Procedure
Caution: Refer to SIR Caution in the Preface section.
- Disable the SIR system. Refer to
SIR Disabling and Enabling
.
- Remove the steering column from the vehicle. Refer to
Steering Column Replacement
.
- Remove the turn signal switch housing. Refer to
Steering Column Tilt Head Replacement
.
- Remove the tilt spring only. Refer to
Steering Column Tilt Spring Replacement
.
- Remove 2 pivot pins (1) from the steering column support assembly using
J 21854-01
.
- Remove the boot seal (5).
- If sensor is not present, remove the following:
7.1. | The steering shaft seal (4) |
7.2. | The sensor retainer (3) |
- If sensor is present, remove the following:
8.1. | The sensor locator (2) |
8.2. | The sensor assembly (1) |
Installation Procedure
- If sensor is not present, install the following:
1.1. | The sensor retainer (3) |
1.2. | The steering shaft seal (4) |
- If sensor is present, install the following
2.1. | The sensor assembly (1) |
The sensor assembly must be aligned to the 9 o'clock position.
2.2. | The sensor locator (2) |
- Install the boot seal (5)
- Install the steering shaft assembly (2) into the steering column tilt head assembly (1).
- Install the tilt head assembly (1) and the steering shaft (3) into
the steering column jacket assembly (2).
Important: Replace the steering column support assembly if the steering column support assembly has been staked 3 times.
- Lubricate the pivot pins with GM P/N 12346293 (Canadian P/N 992723). Install the 2 pivot pins onto the steering column support assembly. Stake the pins in 3 places.
- Install the tilt spring assembly only. Refer to
Steering Column Tilt Spring Replacement
.
Caution: Improper routing of the wire harness assembly may damage the inflatable
restraint steering wheel module coil. This may result in a malfunction of
the coil, which may cause personal injury.
- Install the turn signal switch housing. Refer to
Steering Column Tilt Head Replacement
.
- Install the steering column to the vehicle. Refer to
Steering Column Replacement
.
- Enable the SIR system. Refer to
SIR Disabling and Enabling
.