Was the entire Exterior Lights System Check performed?

--

Go to Step 2

Go to Exterior Lights System Check

1. Turn the ignition switch to ON position.
2. Backprobe the turn signal switch connector C202 with a DMM from cavity C5 (PNK) to ground.

Is the voltage within the specified range?

10-15 V

Go to Step 3

Go to Step 4

Replace the turn signal switch. Refer to Turn Signal and Multifunction Switch Assembly - Off Vehicle in Steering Wheel and Column-Tilt.

Is the turn signal switch replacement complete?

--

Go to Exterior Lights System Check

--

Check the rear junction block IGN 1 Fuse for an open.

Is the IGN 1 Fuse OK?

--

Go to Step 7

Go to Step 5

Repair the short to ground in CKT 1039 (PNK). Check all wiring that is fed by the IGN 1 Fuse. Refer to Wiring Repairs in Wiring Systems.

Is the circuit repair complete?

--

Go to Step 6

--

Replace the IGN 1 Fuse. Refer to Wiring Repairs in Wiring Systems.

Is the IGN 1 Fuse replacement complete?

--

Go to Exterior Lights System Check

--

Repair the open in CKT 1039 (PNK) between the rear junction block and the turn signal switch. Refer to Wiring Repairs in Wiring Systems.

Is the circuit repair complete?

--

Go to Exterior Lights System Check

--