Was the entire Exterior Lights System Check performed?

--

Go to Step 2

Go to Exterior Lights System Check

Do the turn lamps flash?

--

Go to Step 3

Go to Step 4

1. Disconnect the hazard switch assembly connector.
2. Connect a DMM from the hazard switch assembly connector cavity B (DK GRN) (LH) or cavity D (LT GRN) (RH) to ground.

Is the voltage within the specified range?

10-15 V

Go to Step 6

Go to Step 5

1. Disconnect the hazard switch assembly connector.
2. Connect a DMM from the hazard switch assembly connector cavity K (LT BLU) (LH) or cavity H (DK BLU) (RH) to ground.

Is the voltage within the specified range?

10-15 V

Go to Step 9

Go to Step 5

Replace the hazard switch assembly. Refer to Hazard Flasher Switch Replacement in Instrument Panel, Gauges and Console.

Is the hazard switch assembly replacement complete?

--

Go to Exterior Lights System Check

--

1. Disconnect the turn signal switch connector C202.
2. Connect a DMM from the turn signal switch cavity B3 (DK GRN) (LH) or cavity B2 (LT GRN) (RH) to ground.

Is the voltage within the specified range?

10-15 V

Go to Step 7

Go to Step 8

Replace the turn signal switch. Refer to Turn Signal and Multifunction Switch Assembly - Off Vehicle in Steering Wheel and Column-Tilt.

Is the turn signal switch replacement complete?

--

Go to Exterior Lights System Check

--

Repair the short to battery positive voltage (B+) in CKT 1428 (DK GRN) (LH) or CKT 1427 (LT GRN) (RH). Refer to Wiring Repairs in Wiring Systems.

Is the circuit repair complete?

--

Go to Exterior Lights System Check

--

Repair the short to battery positive voltage (B+) in CKT 14 (LT BLU) (LH) or CKT 15 (DK BLU) (RH). Refer to Wiring Repairs in Wiring Systems.

Is the circuit repair complete?

--

Go to Exterior Lights System Check

--