Door Outside Handle Replacement Front

1. Place window in full up position.



2. Remove the door trim panel. Refer to Door Trim Panel Replacement
3. Remove the water deflector. Refer to Front Side Door Water Deflector Replacement
4. Remove the front door handle nut.



5. Remove the rear door handle nut.



6. Disconnect the lock cylinder rod from the door latch (driver's door only).



7. Disconnect the outside door handle rod (1) by opening the retainer (2) at door latch.



8. Push up on the handle retention clip and remove the door handle and rods.

1. Install the handle by inserting rods through the door opening first

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the nuts.

Tighten
Tighten the outside door handle nuts to 7 N·m (62 lb in).




3. Connect the lock cylinder rod to the door latch on the driver's door.



4. Push the door handle rod (1) up to remove play and install into the clip (2) on the door latch assembly.

Important: Check for the proper operation of the door handle and lock cylinder before installing the water deflector and door trim panel.

5. Install the water deflector. Refer to Front Side Door Water Deflector Replacement
6. Install the door trim panel. Refer to Door Trim Panel Replacement
7. Check the window and door controls for proper operation.

Door Outside Handle Replacement Rear

1. Remove the door trim panel. Refer to Door Trim Panel Replacement
2. Remove the water deflector. Refer to Rear Side Door Water Deflector Replacement



3. Disconnect the outside door handle rod (1) by opening the retainer (2).



4. Remove the two nuts (2).
5. Remove the door handle (1) from the door.

1. Install the outside door handle (1) into the door.
2. Align the studs through the holes in the door .

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the nuts (2).

Tighten
Tighten the outside door handle nuts to 7 N·m (62 lb in).




4. Push up on the door handle rod (1) to remove play and install into the clip (2) on the door latch assembly.

Important: Check for the proper operation of the door handle before installing the water deflector and door trim panel.

5. Install the water deflector. Refer to Rear Side Door Water Deflector Replacement
6. Install the door trim panel. Refer to Door Trim Panel Replacement