Seat Back Recliner Sensor Replacement for Cadillac Seville 1998

1. Disable the SIR system. Refer to Disabling the SIR System in SIR.
2. Remove the front bucket seat. Refer to Front Seat Replacement - Bucket .
3. Remove the seat back trim cover. Refer to Front Seat Back Trim Replacement .



4. Remove retainer clip from the recliner motor end of the recliner shaft.



5. Slide the recliner shaft out of recliner motor sensor (outboard side) far enough to clear sensor.
6. Disconnect sensor electrical connector from beneath the seat .
7. Release sensor from the recliner gear drive case.

1. Install sensor on the recliner gear case (snaps into place).



2. Slide recliner shaft back through the sensor and gear case.



3. Install the retaining clip onto the recliner shaft.
4. Install the electrical connector.
5. Install the rear seat belt post cover.
6. Install the seat back trim cover. Refer to Front Seat Back Trim Replacement .
7. Install the front bucket seat. Refer to Front Seat Replacement - Bucket .
8. Enable the SIR system. Refer to Enabling the SIR System in SIR.