Instrument Panel Upper Trim Pad Replacement LHD

1. Disable the SIR system. Refer to Disabling the SIR System in SIR.



2. Remove left and right windshield garnish moldings. Refer to Windshield Pillar Garnish Molding Replacement in Interior Trim.
3. Remove air outlets. Refer to Air Outlet Replacement .
4. Remove fasteners (2) from inside of the vent outlet holes to upper pad.
5. Lift pad (1) upward from rear edge over IP cluster to disengage retainers from IP cluster trim plate.
6. Lift pad on an angle and slide rearward to disengage front retainers at front of dash. It may be necessary to push down on right front edge to disengage retainer from carrier forward of PSIR location.



7. Disconnect electrical connector (1).
8. Remove the trim pad (2) from the vehicle.
9. Remove the speakers from the trim pad. Refer to Speaker Replacement in Entertainment.
10. Straighten the speaker grilles mounting tabs.

Remove the speaker grilles from the trim pad.

11. Remove the speaker wiring harness from the trim pad.

1. Install the speaker wiring harness to the trim pad.
2. Install the speaker grilles to the trim pad.

Fold the speaker grilles retaining tabs over to secure the grilles.

3. Install the speakers to the trim pad. Refer to Speaker Replacement in Entertainment.



4. Set pad onto IP and reconnect the electrical connection (1).



5. Slide pad forward to engage front retainers to IP carrier.
6. Align rear edge of pad (1) with IP cluster bezel and snap retainers into upper pad.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

7. Install fasteners (2) into A/C duct openings.

Tighten
Tighten the trim panel fasteners to 2 N·m (18 lb in).

8. Install air outlets. Refer to Air Outlet Replacement .
9. Install left and right windshield garnish moldings. Refer to Windshield Pillar Garnish Molding Replacement in Interior Trim.
10. Enable the SIR. Refer to Enabling the SIR System in SIR.