Air Inlet Actuator Replacement LHD

1. Remove the IP compartment. Refer to Instrument Panel Compartment Replacement in Instrument Panel, Gauges and Console.
2. Remove the right sound insulator. Refer to Instrument Panel Insulator Panel Replacement - Right Side in Instrument Panel, Gauges and Console.
3. Remove the DIM module from the bracket.
4. Remove the rear two DIM module bracket screws.
5. Reposition the DIM module bracket to gain access to the air inlet actuator.



6. Remove the air inlet actuator retaining screws (1).
7. Remove the electrical connector from the air inlet actuator.



8. Remove the air inlet actuator.

1. Install the air inlet actuator.




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the air inlet actuator retaining screws (1).

Tighten
Tighten the fasteners to 1.2 N·m (12 lb in).

3. Install the electrical connector to the air inlet actuator.



4. Position the DIM module bracket to its original position.
5. Install the rear two DIM module bracket retaining screws.
6. Install the DIM module into the bracket.
7. Install the right sound insulator. Refer to Instrument Panel Insulator Panel Replacement - Right Side in Instrument Panel, Gauges and Console.
8. Install the IP compartment. Refer to Instrument Panel Compartment Replacement in Instrument Panel, Gauges and Console.

Air Inlet Actuator Replacement RHD

1. Remove the IP compartment. Refer to Instrument Panel Compartment Replacement in Instrument Panel, Gauges and Console.
2. Remove the left sound insulator. Refer to Instrument Panel Insulator Panel Replacement - Left Side in Instrument Panel, Gauges and Console.
3. Remove the DIM module from the bracket.
4. Remove the rear two DIM module bracket screws.
5. Reposition the DIM module bracket to gain access to the air inlet actuator.
6. Remove the electrical connector from the air inlet actuator.
7. Remove the air inlet actuator retaining screws (1).



8. Remove the air inlet actuator.

1. Install the air inlet actuator.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the air inlet actuator retaining screws (1).

Tighten
Tighten the fasteners to 1.2 N·m (12 lb in).

3. Install the electrical connector to the air inlet actuator.
4. Position the DIM module bracket to its original position.
5. Install the rear two DIM module bracket retaining screws.
6. Install the DIM module into the bracket.
7. Install the left sound insulator. Refer to Instrument Panel Insulator Panel Replacement - Left Side in Instrument Panel, Gauges and Console.
8. Install the IP compartment. Refer to Instrument Panel Compartment Replacement in Instrument Panel, Gauges and Console.