Tools Required

J 24319-B Steering Linkage and Tie Rod Puller

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
3. Remove the outer tie rod end (1) retaining nut (2).



4. Loosen the jam nut (2) on the inner tie rod end (1).



5. Remove the outer tie rod end from the steering knuckle using J 24319-B .



6. Remove the outer tie rod end (3) from the inner tie rod end (1).

1. Install the outer tie rod end (3) to the inner tie rod end (1). Do not tighten the jam nut (2).



2. Connect the outer tie rod end (2) to the steering knuckle (1).




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the outer tie rod end retaining nut (2).

Tighten
Tighten the outer tie rod end retaining nut to 47 N·m (35 lb ft).

4. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
5. Lower the vehicle.

Important: Be sure the rack and pinion boot is not twisted or puckered during toe adjustment.

6. Adjust the toe alignment. Refer to Front Toe Adjustment in Wheel Alignment.