Instrument Panel Accessory Trim Plate Replacement - Left Side LHD

Caution: Refer to SIR Caution in the Preface section.




1. Disable the SIR system. Refer to SIR Disabling and Enabling and SIR Disabling and Enabling in SIR.
2. Remove the instrument panel (I/P) upper trim pad. Refer to Instrument Panel Upper Trim Pad Replacement .
3. Remove the I/P cluster trim panel. Instrument Cluster Trim Panel Replacement .
4. Remove the screw near the I/P cluster at the I/P retainer.
5. Lift the outboard end of the trim plate in order to disengage the locating tab, then pull the trim plate rearward.

1. Align the trim panel with the I/P retainer.
2. Push forward on the trim plate in order to engage the three retainers, while aligning the A/C housing with the A/C ducts.

Notice: Refer to Fastener Notice in the Preface section.

3. Install the screws.

Tighten
Tighten the screws to 2 N·m (18 lb in).

4. Install the I/P cluster trim panel. Refer to Instrument Cluster Trim Panel Replacement .
5. Install the instrument panel (I/P) upper trim pad. Refer to Instrument Panel Upper Trim Pad Replacement .
6. Enable the SIR system. Refer to SIR Disabling and Enabling and SIR Disabling and Enabling in SIR.

Instrument Panel Accessory Trim Plate Replacement - Left Side RHD

Caution: Refer to SIR Caution in the Preface section.




1. Disable the SIR. Refer to SIR Disabling and Enabling and SIR Disabling and Enabling in SIR.
2. Remove the instrument panel (I/P) upper trim pad. Refer to Instrument Panel Upper Trim Pad Replacement .
3. Remove the I/P cluster trim panel. Refer to Instrument Cluster Trim Panel Replacement .
4. Remove the inflatable restraint instrument panel module. Refer to Inflatable Restraint Instrument Panel Module Replacement in SIR.
5. Remove the screws from trim panel.



6. Remove the two screws from the straps at the carrier.
7. Pull rearward on the trim panel in order to remove the trim panel.

1. Align the trim panel with the I/P retainer.
2. Push forward on the trim plate in order to engage the three retainers, while aligning the A/C housing with the A/C ducts.

Notice: Refer to Fastener Notice in the Preface section.

3. Install the screws.

Tighten
Tighten the screws to 2 N·m (18 lb in).




4. Install the screws through the straps to the carrier.

Tighten
Tighten the screws to 2 N·m (18 lb in).

5. Install the I/P cluster trim panel. Instrument Cluster Trim Panel Replacement .
6. Install the inflatable restraint instrument panel module. Refer to Inflatable Restraint Instrument Panel Module Replacement in SIR.
7. Install the I/P upper trim pad. Refer to Instrument Panel Upper Trim Pad Replacement .
8. Enable the SIR. Refer to SIR Disabling and Enabling and SIR Disabling and Enabling in SIR.