GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2009 🢒 XLR 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Driver or Passenger Seat Side Inflatable Restraint Module Replacement

Removal Procedure

    Warning: Refer to SIR Inflator Module Handling and Storage Warning in the Preface section.

    Warning: Following the deployment of a side impact air bag, inspect the following parts for damage. Replace these parts if necessary:

       • The seat cushion frame
       • The seat recliner, if equipped
       • The seat adjuster
       • The seat back frame
    Failure to do so may cause future personal injury.

  1. Disable the SIR system. Refer to SIR Disabling and Enabling.

    2. Object Number: 1276243 Size: SH
  2. Remove the front seat. Refer to Driver or Passenger Seat Replacement.
  3. Remove the seat back cover. Refer to Driver Seat Back Cushion Pad Replacement or to Passenger Seat Back Cushion Pad Replacement.
  4. Remove the retaining bolts that attach the inflatable restraint side impact module to the seat frame.

    5. Object Number: 1328112 Size: SH
  5. Remove the side impact module retainer from the seat back cushion cover.

    6. Object Number: 1276234 Size: SH
  6. Remove the wiring harness retaining clips from the seat frame.

    7. Note: Note the routing of the inflatable restraint side impact module wiring harness and the retaining clips within the seat frame. You must route the wiring harness in the exact same way as the factory to eliminate the possibility of any cutting or chafing of the wiring harness.

  7. Remove the wiring harness from the seat frame.
  8. Remove the side impact module from the seat frame.
  9. Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required retention period. Refer to Inflator Module Handling and Scrapping.

Installation Procedure

    Object Number: 1276234 Size: SH
  1. Install the module wiring harness to the seat frame while guiding the wiring harness through the appropriate spots on the seat frame.
  2. Install the wiring harness retaining clips to the seat frame.

    3. Object Number: 1276243 Size: SH
  3. Install the side impact module to the seat frame.

    4. Object Number: 1328112 Size: SH
  4. Install the side impact module retainer to the seat back cushion cover.

    5. Caution: Refer to Fastener Caution in the Preface section.

  5. Install the retaining bolts to the side impact module and tighten to 10 N·m (89 lb in).
  6. Install the seat back cover. Refer to Driver Seat Back Cushion Pad Replacement or to Passenger Seat Back Cushion Pad Replacement.
  7. Install the front seat. Refer to Driver or Passenger Seat Replacement.
  8. Enable the SIR system. Refer to SIR Disabling and Enabling.