Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

Important: Observe the alignment of the rotor in relation to the reluctor wheel. The rotor must be reinstalled in the exact position the rotor was in prior to removal.

Important: Do not use the old cap, CMP sensor, and rotor screws. Use replacement screws that have been coated with a thread locking compound. Precoated replacement cap and CMP sensor screws can be acquired using P/N 10475922 (pkg of 10 screws). Precoated replacement rotor screws can be acquired using P/N 10475924 (pkg of 10 screws).

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

Tighten
Tighten the bolts to 2.2 N·m (19 lb in).

Tighten
Tighten the bolts to 1.9 N·m (18 lb in).

Tighten
Tighten the bolts to 2.4 N·m (21 lb in).