Ignition and Key Alarm Switch Assembly - Assemble - Off Vehicle for Chevrolet Astro - 2WD 2000

1. Install the ignition and key alarm switch assembly (3) onto the electronic lock module assembly (2)

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the 2 tapping screws into the ignition and key alarm switch assembly (3).

Tighten
Tighten the screws to 1.5 N·m (13 lb in).

3. Install the key alarm connector (1) into the electronic lock module assembly (2).



4. Slide the 2 connectors (2) onto the bulk head connector (1).



5. Install the wire harness strap (2) into the steering column tilt head assembly (1).
6. Install  wire harness straps (3) onto the wire harness assembly (4).
7. Install the wire harness assembly (4) into the wire harness strap (5).
8. Install the upper and lower trim covers. Refer to Steering Column Trim Covers - Assemble - Off Vehicle .