GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2000 🢒 Astro - 2WD 🢒 Body and Accessories 🢒 Body Rear End 🢒 Rear Door Inside Handle Replacement

Removal Procedure
  1. Remove the trim panel. Refer to Rear Door Trim Panel Replacement .
  2. Remove the water deflector. Refer to Water Deflector Replacement .
  3. Remove the control rods from the door lock.
  4. Remove the door handle nuts.
  5. Remove the door handle from the door.

Installation Procedure
  1. Install the clips to the door handle.
  2. Install the door handle to the door.

    3. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the door handle nuts.

    4. Tighten
    Tighten the door handle nuts to 11 N·m (97 lb in).

    Important: Install new control rod retainers whenever they are removed.

  4. Install the control rod to the door handle.
  5. Install the water deflector. Refer to Water Deflector Replacement .
  6. Install the door trim pad. Refer to Rear Door Trim Panel Replacement .