Removal Procedure
- Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.
- Remove the engine cover. Refer to Engine Cover Replacement in Interior Trim.
- Remove the engine cooling fan. Refer to Fan Replacement in Engine Cooling.
- Remove the air conditioning compressor, if equipped. Refer to Air Conditioning Compressor Replacement in Heating, Ventilation and Air Conditioning.
- Remove the nut holding the power steering pump rear bracket to the engine front bracket stud.
- Remove the power steering pump mounting bracket and set aside.
- Remove the power steering pump mounting bracket stud from the cylinder head.
- Remove the intake manifold. Refer to Lower Intake Manifold Replacement .
- Remove the exhaust manifold. Refer to Exhaust Manifold Replacement - Left Side in Engine Exhaust.
- Remove the ground wires at the rear of the left cylinder head.
- Remove the A/C pipe bracket nut, if equipped.
- Remove the fuel pipe bracket bolt at the rear of the cylinder head.
- Remove the valve push rods. Refer to Valve Rocker Arm and Push Rod Replacement .
- Remove the cylinder head and the gasket. Refer to Cylinder Head Removal - Left Side .
- Clean the engine block and the cylinder head sealing surfaces.
- Clean the cylinder head bolts and the engine block bolt holes.
- For further service to the cylinder head refer to the following:
Important: The power steering pump can remain on the power steering pump mounting bracket. The pump hoses can remain attached to the pump.
Notice: Clean all dirt, debris, and coolant from the engine block cylinder head bolt holes. Failure to remove all foreign material may result in damaged threads, improperly tightened fasteners or damage to components.
Installation Procedure
- Install the cylinder head. Refer to Cylinder Head Installation - Left Side .
- Install the valve push rods. Refer to Valve Rocker Arm and Push Rod Replacement .
- Install the ground wires and bolt at the rear of the left cylinder head.
- Install the fuel pipe bracket and stud at the rear of the cylinder head.
- Install the A/C pipe bracket and nut, if equipped.
- Install the exhaust manifold. Refer to Exhaust Manifold Replacement - Left Side in Engine Exhaust.
- Install the intake manifold. Refer to Lower Intake Manifold Replacement .
- Install the stud for the power steering pump mounting bracket to the cylinder head.
- Install the power steering pump mounting bracket.
- Install the nut holding the power steering pump rear bracket to the engine front bracket stud.
- Install the air conditioning compressor. Refer to Air Conditioning Compressor Replacement in Heating, Ventilation and Air Conditioning.
- Install the engine cooling fan. Refer to Fan Replacement in Engine Cooling.
- Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.
- Install the engine cover. Refer to Engine Cover Replacement in Interior Trim.
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the ground wire bolt to 35 N·m (26 lb ft).
Tighten
Tighten the fuel pipe bracket stud to 33 N·m (24 lb ft).
Tighten
Tighten the A/C pipe bracket nut to 35 N·m (26 lb ft).
Tighten
Tighten the power steering pump mounting bracket stud to 20 N·m
(15 lb ft).
Tighten
Tighten the power steering pump rear bracket nut to 41 N·m (30 lb ft).
