Caution: Refer to Battery Disconnect Caution in the Preface section.
- Disconnect the negative battery cable.
- Remove the HVAC control assembly. Refer to
Heater and Air Conditioning Control Replacement
.
- Remove the screws that secure the switch assembly to the knob mount support.
- Remove the switch assembly. Note the position of the spring, the electrical contact washer, and the contact key/keyway on the knob post.
Installation Procedure
- Install the spring and the electrical contact washer over the blower switch knob post.
- Align the contact key with the post keyway.
- Position the switch assembly over the mount posts.
- Install the switch assembly with the screws.
- Connect the electrical connectors to the rear of the control assembly.
- Install the HVAC control assembly. Refer to
Heater and Air Conditioning Control Replacement
.
- Connect the negative battery cable.
- Perform an operational check of the blower switch positions.